Canon imageRUNNER ADVANCE 8105 Series Service Manual page 562

6
3-3) Check if the toner blown by the blower is attached to the Developing Roller; if the
toner is attached, wipe it with lint-free paper.
(Otherwise, the toner is fused to the Roller that causes banding)
6
Troubleshooting > Image Faults > Separation Failure Jam due to Deformation of Separation Claw
F-6-20 F-6-20
Troubleshooting > Image Faults > Separation Failure Jam due to Deformation of Separation Claw
Separation Failure Jam due to Deformation of
Separation Claw
[Location]
Drum Separation Claw
[Cause]
When the paper enters to the drum at separation failure, the Separation Claw may be
deformed. When the Separation Claw is deformed, the paper is easily caught by the leading
edge of the Separation Claw when the paper (especially curled paper) is fed, and a jam (Jam
Code: 0205) is likely to occur.
[Condition]
Job after a jam which occurs when the paper enters to the drum
When using curled paper (when using backside of printed paper, etc.)
[Field Remedy]
Replace the Separation Claw.
MEMO:
Replace the Separation Claw when a separation failure jam occurs even once..
6-15
F-6-21 F-6-21
6-15