Copying System Software; Downloading The System Software - Canon imageRUNNER ADVANCE 8105 Series Service Manual

●

Downloading the System Software

System software is saved in the temporary storage area on HDD after downloaded with SST.
Restart the machine after download so that it will be written to the system area, and the flash
ROM.
After the writing has been completed normally, this machine automatically restarts with the
new system software.
1)
System
Software
2)
HDD
3) Writing takes place.
System
<<<<< download shell >>>>> Software
[ SYSTEM JPja-m ] - - - - Upgrading complete
[ SYSTEM ZZ ] - - - - - - - Upgrading complete
Temporary
[ SYSTEM JPja-w ] - - - - Upgrading complete
[ SYSTEM ZZ ] - - - - - - - Upgrading complete
[ FONT F ] - - - - - - - - - - Upgrading complete
storage area
[ FONT G ] - - - - - - - - - - Upgrading complete
+++ Switch OFF the power then ON. +++
System area
BOOT area
FLASH
ROM
6
Troubleshooting > Version upgrade > Version Upgrade via SST > Copying System Software
The system software is downloaded.
- - - Download Mode - - -
[ iR2270i-JPjaxxxx-MN.dsh ] - - - - - - - - - - Complete
[ iR2270iM-JPjaxxxx-1F77-MN.PRG ] - - - - Complete
[ iR2270iM-ZZjaxxxx-49AD.PRG ] - - - - - - - Complete
[ iR2270iW-JPjaxxxx-5C16-MN.PRG ] - - - - Complete
[ iR2270iW-ZZjaxxxx-A825.PRG ] - - - - - - - Complete
[ iR2270iF-JPjaxxxx-DE96-ICC.PRG ] - - - - Complete
[ iR2270iW-ZZjaxxxx-A825.PRG ] - - - - - - - Complete
[ iR2270iG-JPjaxxxx-EC30-ICC.PRG ] - - - - Complete
HDD
System
Software
Temporary
storage area
The main power switch is turned off and then on.
4) The main power switch is turned off and then on.
5) The machine starts up using the new version.
6
Troubleshooting > Version upgrade > Version Upgrade via SST > Copying System Software
■

Copying System Software

●
System CD -> SST
Copy the system software stored in the system CD to SST.
MEMO:
The system software is compressed if the file size exceeds the CD memory capacity.
If the above is the case, decompress the file before copying it to SST.
Preparation
Requirements:
• PC with SST Ver.4.22 or later installed
•
The system CD for this machine
Steps to copy the system software
1) Start the PC
2) Set the system CD in the PC
3) Start SST
4) Click "Register Firmware" button.
F-6-62 F-6-62
6-37
F-6-63 F-6-63
6-37