Cleaning The Drum Edges - Canon imageRUNNER ADVANCE 8105 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Cleaning the Drum edges
4) Rotate the drum for the width (5 to 10 cm), and repeat the step 3 through 5 until the entire
area of the surface has been cleaned.
4
Parts Replacement and Clearning > Image Formation System > Cleaning the Drum edges
F-4-166

Cleaning the Drum edges

<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Primary Charging Assembly. (Refer to page 4-96)
3. Remove the Pre-transfer Charging Assembly. (Refer to page 4-106)
4. Remove the Process Unit. (Refer to page 4-114)
5. Put paper on the Photosensitive Drum, so that it is not exposed to direct sunlight.
6. Remove the Drum Cleaning Blade. (Refer to page 4-117)
7. Remove the Drum Retainer Plate.
8. Remove the Drum Unit. (Refer to page 4-121)
<Procedure>
1) Rotate the Drum and dry wipe the soiling on the surface of the Drum edges with lint-free
paper.
4-126
F-4-167
4-126