Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1280

■
Installing the Encryption Board
The following shows combination of the HDD and the Encryption Board.
<When a single HDD is installed>
•
Connect "CH A" to Slot.1 (The original HDD)
•
No HDD to Slot.2
B
C H
A
C H
<When 2 HDDs are installed>
•
Connect "CH A" to Slot.1 (The original HDD)
• Connect "CH B" to Slot.2 (The new HDD)
B
C H
A
C H
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
Power Supply Cable
Signal Cable
Signal Cable
Power Supply Cable
F-9-639
Power Supply Cable
Signal Cable
Signal Cable
Power Supply Cable
F-9-640
9
Installation > HDD Data Encryption & Mirroring Kit-C2 > In the Case of Fixed HDD > Installing the Encryption Board
1) Open the Controller Box, and free the Signal Cable and the Power Supply Cable of the
host machine from the 4 Wire Saddles and the Edge Saddle at the back of the HDD Case
Unit.
x5
9-318
F-9-641
9-318