Toner Stirring; Installation Of The Host Machine; Other Installation Work - Canon imageRUNNER ADVANCE 8105 Series Service Manual

Toner Stirring

1) Check that "Check the developer" is displayed in the following service mode.
COPIER > FUNCTION > INSTALL > TONER-S
2) Press "OK" after checking the installation of the Developing Assembly and the Developing
Assembly Pressure Plate.
3) Toner supply is executed. (For approx. 12 minutes. Countdown is shown on the screen)
MEMO:
While stirring toner,"Installation of the Host Machine", "Other Installation Work",
"Setting the Deck" and "Setting the Paper Cassette" can be executed.

Installation of the Host Machine

1) Confirm the position to install the Host Machine and turn the 2 adjusters with your hand
until they closely contact the floor.
MEMO:
If you failed to turn the adjusters with your hand, use a screwdriver so that they can be
turned by your hand.
2) Use a screwdriver to turn the adjusters in the direction of the arrow to make them secured.
9
Installation > Installation > Other Installation Work

Other Installation Work

<Service Book Holder>
Remove the double-sided tape on back side of the Service Book Holder, and affix the holder
on the Base Plate of the host machine.
<Finisher Connector Cover>
Install the 2 Finisher Connector Covers to the left side of the host machine.
•
1 Protrusion each
•
1 Claw each
F-9-60 F-9-60
9
Installation > Installation > Other Installation Work
9-29
F-9-61 F-9-61
Claw
Protrusion
F-9-62 F-9-62
9-29