Removing The Pre-Transfer Charging Wire Cleaner, Cleaner Holder - Canon imageRUNNER ADVANCE 8105 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Wire Cleaner, Cleaner Holder
Removing the Pre-transfer Charging Wire Cleaner,
Cleaner Holder
<Preparation>
1. Open the Inner Cover. (Refer to "Removing the Primary Charging Assembly")
2. Remove the Pre-transfer Charging Assembly. (Refer to page 4-106)
<Procedure>
1) Displace the Shield Plate Retainer Block to open the Shield Plate in the direction of the
arrow.
•
1 Screw (to loosen)
4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Wire Cleaner, Cleaner Holder
Note: Points to Note when Securing the Shield Plate
Move the Shield Plate Retainer Block fully to the inside to secure with the screw.
Check that the rear Pin is fitted into the Frame hole, and then move the Shield Plate
back and forth to check that the Shield Plate is secured.
Loosen
F-4-121
4-108
F-4-122
4-108