9) Open the Controller Box, and disconnect the Signal Cable and the Power Supply Cable on
the host machine. (Disconnected cables will not be used.)
•
2 Connectors
•
9 Wire Saddles
•
2 Edge Saddles
x2
x11
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
10) Remove the HDD Case Unit.
•
2 Screws (The removed screws will be used in "Installing the HDD Case Unit" step 1).)
■
Changing Configuration inside of HDD Case Unit
1) Remove the E-ring from the removed HDD Case Unit, remove the shaft of the HDD Cap,
and then remove the HDD Fixed Plate. (The removed HDD Fixed Plate will not be used.)
F-9-290
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
x2
F-9-291
HDD Fixed Plate
F-9-292
9-132
9-132