Processing When Reaplacing The Part - Canon imageRUNNER ADVANCE 8105 Series Service Manual

4
Parts Replacement and Clearning > Image Formation System > Removing the Photosensitive Drum
Note:
• Align the yellow marker of the drum with the hole position of the unit when installing
the Heater Control PCB Unit to the drum.
• When securing the Flange, align the protrusion of the Flange with the yellow marker
to install.
4
Parts Replacement and Clearning > Image Formation System > Removing the Photosensitive Drum
<Processing when reaplacing the parts>
<Procedure of adjustment>
1) Clear the parts counter. (COPIER>COUNTER>DRBL-1>PT-DRM)
2) Replace with the ROM packaged with the Drum.
2-1)Remove the Drum EEPROM.
•
1 Screw
• 1 Connector
F-4-161
F-4-162
MEMO:
If the yellow marker is not aligned with the protrusion, the following control cannot be
executed properly.
1. 2D shading
2. D-MAX control
3. D-half control
MEMO :
If the ROM is not replaced, the replaced drum and the drum-unique data stored in the
ROM data are not matched. As a result, when the 2D shading function is enabled, it is
not functioned normally.
4-124
F-4-163
4-124