Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1247

11) Secure the Signal Cable and the Power Supply Cable in place using the 3 Wire Saddles.
x3
CAUTION:
Check that the connector of the Signal Cable is connected properly and that the cable
is not overloaded.
9
Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Installing the Encryption Board and
12) Put the CH B cable through the Wire Saddle.
13) Fold the extra length of the CH A cable, and secure it with the Wire Saddle.
CAUTION:
•
•
•
F-9-574
F-9-575
9
Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Installing the Encryption Board and
Be sure that the cable is not in contact with the stepped screw [A] of Drawer.
When securing the cable, be sure that it does not go over to the front.
When the FAX Board is installed, be sure to avoid contact of the cable with the PCB
to secure the cable.
[A]
CH B
9-285
CH A
F-9-576
9-285