Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1078

2) Put the HDD Cap and the shaft back to the HDD Case Unit, and secure the HDD Case Unit
with the E-ring.
3) Remove the Upper Rail from the HDD Case Unit.
•
2 Screws (The removed screws will be used in step 6).)
x2
4) Remove the Leaf Spring from the removed rail in the order of the arrows in the figure
below. (The removed Leaf Spring will not be used.)
• 2 Bosses
•
2 Arms
Boss
Boss
Turn over
9
Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
5) Install the HDD Lock Pin and the HDD Lock Spring to the removed rail.
6) Return the rail to its original position.
•
2 Bosses
•
2 Screws (Use the screws removed in step 3).)
F-9-260 F-9-260
7) Insert the HDD Drawer Unit into the hole on the HDD Case Unit to install it.
•
2 Screws (TP Round End; M3x6)
8) Close the Edge Saddle.
Arm
F-9-261 F-9-261
9 Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
Hole
Hole
x2
Boss
Boss
x2
9-116
F-9-262 F-9-262
Edge Saddle
F-9-263 F-9-263
9-116