Canon imageRUNNER ADVANCE 8105 Series Service Manual page 1242

■ Changing Configuration inside of HDD Case Unit
1) Remove the E-ring from the removed HDD Case Unit, remove the shaft of the HDD Cap,
and then remove the HDD Fixed Plate. (The removed HDD Fixed Plate will not be used.)
HDD Fixed Plate
2) Put the HDD Cap and the shaft back to the HDD Case Unit, and secure the HDD Case Unit
with the E-ring.
3) Remove the Upper Rail from the HDD Case Unit.
•
2 Screws (The removed screws will be used in step 6).)
x2
9
Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing Configuration inside of H
4) Remove the Leaf Spring from the removed rail in the order of the arrows in the figure
below. (The removed Leaf Spring will not be used.)
•
2 Bosses
•
2 Arms
Boss
F-9-559
5) Install the HDD Lock Pin and the HDD Lock Spring to the removed rail.
6) Return the rail to its original position.
•
2 Bosses
• 2 Screws (Use the screws removed in step 3).)
F-9-560
9 Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing Configuration inside of H
Boss
Turn over
Hole
Hole
x2
Boss
Boss
9-280
Arm
F-9-561
F-9-562
9-280