Canon imageRUNNER ADVANCE 8105 Series Service Manual page 444

4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly Shutter Unit
3) Install the Motor Unit.
•
3 Claws
x3
CAUTION:
Be sure to feel tension when installing the spring; otherwise, it can cause image error.
4) Set the spring.
4
Parts Replacement and Clearning > Image Formation System > Removing the Pre-transfer Charging Assembly Shutter Unit
Note: Points to Note when Securing the Shield Plate
Be sure to check that the rear pin is fit into the frame hole.
5) Move the Shield Plate Retainer Block fully to the inside to secure with the screw.
MEMO:
Move the Shield Plate back and forth to check that the Shield Plate is secured.
F-4-223
4-148
F-4-224
4-148