Ntp-Service Authentication Enable - Huawei Quidway S2000 Series Command Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches
View
System view
Parameter
query: Allow to control query authority.
synchronization: Only allow the server to access.
server: Allow query to server and access.
peer: Full access authority.
acl-number: IP address list number, ranging from 2000 to 2999.
Description
Using ntp-service access command, you can set the authority to access the local
equipment. Using undo ntp-service access command, you can cancel the access
authority settings.
By default, there is no limit to the access.
Set authority to access the NTP services on a local Ethernet Switch. This is a basic and
brief security measure, compared to authentication. An access request will be matched
with peer, serve, serve only, and query only in an ascending order of the limitation.
The first matched authority will be given.
Example
# Give the authority of time request, query control and synchronization with the local
equipment to the peer in ACL 2076.
[Quidway] ntp-service access peer 2076
# Give the authority of time request and query control of the local equipment to the peer
in ACL 2028.
[Quidway] ntp-service access synchronization 2028

7.1.6 ntp-service authentication enable

Syntax
ntp-service authentication enable
undo ntp-service authentication enable
Chapter 7 NTP Configuration Commands
7-5