Enabling The Ip Session Function; Binding A User Authentication Domain To A Sub-Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
l
l
Data Preparation
To configure IP session, you need the following data.
No.
1
2
3

4.3.2 Enabling the IP Session Function

Before enabling IP session on a sub-interface, you must enable DHCP globally.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dhcp enable
DHCP is enabled globally.
Step 3 Run:
interface interface-type interface-number.subinterface-number
The sub-interface view is displayed.
Currently, the IP session function can be enabled only in other sub-interfaces view except for
the XGE sub-interface.
Step 4 Run:
ip-session enable
The IP session function is enabled.
----End

4.3.3 Binding a User Authentication Domain to a Sub-Interface

If a user authentication domain is bound to a sub-interface, when a user goes online, the
S9300&S9300E selects the bound domain to authenticate and authorize the user.
Issue 01 (2012-03-15)
Setting physical parameters of a sub-interface
Creating a VPN instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 IP Session Configuration
Data
User name and password
Name of the user authentication domain
VLAN ID on the interface, which cannot be
an existing one
92