Logging In To The Switch For The First Time - Huawei S2700 Series Quick Start Manual

9 Logging In to the Switch for the First Time

9.1 Using the Web System for the First Login
Before You Start
You can directly connect the PC to the ETH management interface or press and hold down the
MODE button to log in to the device through the web system for the first time:
For a device with the ETH management interface, you can directly connect the PC to the ETH
management interface to log in to the device through the web system for the first time.
For a device with the MODE button, you can press and hold down the MODE button to log in to
the device through the web system for the first time.
The following series switches (running V200R012C00 or a later version) support first login through
the web system by directly connecting the PC to the ETH management interface:
S5700S-X-LI, S5710-X-LI, S5720-SI, S5720S-SI, S5720-EI (only the models with the ETH interface),
S5720-HI, S5730, S5730S, S5731, S5731S, S5732, S5735 (only the models with the ETH interface),
S5735S (only the models with the ETH interface), S5736, S6720, S6720S, S6730
and S6730S.
The following series switches support first login through the web system by pressing and holding
down the MODE button:
S2720, S2750, S2730S, S5700-LI, S5700S-LI, S5720-LI, S5720S-LI, S5710-X-LI, S5720-SI, S5720S-SI,
S5720-EI (only the models with the MODE button), S5720-HI, S5730, S5730S, S5731, S5731S,
S5732, S5735, S5735S, S5736, S6720 (only the models with the MODE button), S6720S (only the
models with the MODE button), and S6730 (only the models with the MODE button).
To support this function, the S2750, S5700-LI, S5700S-LI, and S5720-HI must run V200R007C00 or
a later version.
The following series switches do not support first login using the web system:
S2700-SI, S2700-EI, S2710-SI, S3700, S5710-C-LI, S5700-SI, S5700-EI, S5710-EI, S5700-HI,
S6700-EI, S6730-H-V2, and S5720-EI that does not provide a MODE button (S5720-50X-EI-AC,
S5720-50X-EI-DC, S5720-50X-EI-46S-AC, S5720-50X-EI-46S-DC)
You can use console ports to log in to the switches that do not support first login using the web
system for the first time. For details, see 9.2 Using the Console Port for the First Login.
If the web pages cannot be displayed normally, your web browser may need an upgrade. For details
about the web browser requirements, see the Web-based Configuration Guide of the switch.
The login page may differ slightly in different versions.
Login Procedure
Step 1 Connect a PC to the device and the device enters the initial configuration mode.
Directly connect the PC to the ETH management interface to log in to the device for the first time.
(Mode 1)
The default IP address of the ETH management interface on a device is 192.168.1.253/24.
Directly connect the PC to the ETH management interface on the device using network cables.
8
except (S6730-H-V2),