Logging In To The Switch For The First Time - Huawei S600-E Series Quick Start Manual

Education network switches

Table of Contents

6 Logging In to the Switch for the First Time

6.1 Using the Web Management System for the First Login

Before You Start

If you do not save the configuration in 10 minutes after entering the initial configuration mode, the system will

exist from this mode and restore the factory settings.

If the web pages cannot be displayed normally, your web browser may need an upgrade. For details about the

web browser requirements, see the Web-based Configuration Guide of the switch.

The login page may differ slightly in different versions.

Step 1

Connect your computer to any Ethernet port of the switch using an Ethernet cable.

Step 2

Hold down the MODE button for over 6s, when all mode indicators turn green, the switch has entered the

initial configuration mode. In this mode, the IP address of the switch is set to 192.168.1.253/24, and the

admin user level is set to 15 automatically.

Step 3

Configure an IP address for the computer, which is in the same network segment as the default IP address

of the switch.

Step 4

Start the web browser on the computer, enter https://192.168.1.253 in the address box, and press Enter to

display the initial login page. Enter the default user name admin and default password admin@huawei.com

and select the language on the login page. Then click GO or press Enter.

Step 5

Configure the switch. The web-based configuration page provides basic and optional configuration items.

The basic configuration enables you to log in to the switch using the web management system, and the

optional configuration enables you to log in to the switch using Telnet or STelnet. Only parameters for the

basic configuration are described below. For details about the optional configuration and more information

about the product, see the Configuration Guide for your switch on the Huawei support website.

Table of Contents