Setting The Supported Type Of Radius Server - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
Note:
The main attributes of the Accounting-On message –– NAS-ID, NAS-IP and session ID
are often generated automatically by the switch. However, you can configure the
NAS-IP using the nas-ip command. Make sure you set a correct and valid NAS-IP
address. Otherwise, the switch automatically selects the IP address of the virtual VLAN
interface as NAS-IP.
II. Configuration preparations
Create the RADIUS scheme and configure the RADIUS authentication/accounting
server in the scheme as CAMS.
III. Configuration tasks
The following table describes the user Re-authentication at reboot configuration tasks.
Table 3-20 User Re-authentication at reboot configuration
Enter system view
Enter RADIUS scheme view
Enable user re-authentication
at reboot

3.3.12 Setting the Supported Type of RADIUS Server

Quidway Series Switches support the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, 201+ and Portal, independently
developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Table 3-21 Setting the supported type of RADIUS server
Setting
RADIUS Server
Restore the Supported Type of
RADIUS Server to the default setting
Item
Operation
the Supported Type
Huawei Technologies Proprietary
Chapter 3 AAA and RADIUS Protocol Configuration
Command
system-view
radius scheme
radius-scheme-name
accounting-on enable
[ send times ] [ interval
interval ]
of server-type { huawei | iphotel | portal |
standard }
undo server-type
3-17
Description
––
––
By default, this feature
is not enabled.
Command