Configuring Guest Vlan; Displaying And Debugging 802.1X - Huawei Quidway S3100 Series Operation Manual

Operation Manual – 802.1x
Quidway S3100 Series Ethernet Switches

1.5.5 Configuring Guest VLAN

Table 1-6 Configure Guest VLAN
Operation
Enter system view
Configure
access method
Enable the Guest
VLAN function
Caution:
The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
Only one Guest VLAN can be configured for each switch.
Supplicant systems that are not authenticated, fail to pass the authentication, or are
offline belong to Guest VLANs.
The Guest VLAN function is not available to switches that are configured not to
authenticate users that use static IP addresses (refer to the dot1x dhcp-launch
command). (Because switches of this type do not send active authentication
packets.)

1.6 Displaying and Debugging 802.1x

You can verify the 802.1x-related configuration by executing the display command in
any view.
You can clear 802.1x-related statistics information by executing the reset command in
user view.
Command
system-view
port dot1x port-method
{ macbased | portbased }
dot1x guest-vlan vlan-id
[ interface interface-list ]
Huawei Technologies Proprietary
1-19
Chapter 1 802.1x Configuration
Description
—
Optional
The default port
method
MAC-address-based. That is,
the macbased keyword is
used by default.
Required
By default, the Guest VLAN
function is disabled.
access
is