Ipv6 Over Ipv4 Tunnel Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
11
About This Chapter
The IPv6 over IPv4 tunnel technology is developed to address the problem in the transition from
IPv4 networks to IPv6 networks.
11.1 Introduction to IPv6 over IPv4
An IPv6 packet is transparently transmitted after being encapsulated into an IPv4 packet.
11.2 IPv6 over IPv4 Supported by the S9300&S9300E
You can configure manual IPv6 over IPv4 tunnels or 6to4 tunnels to interconnect IPv6 networks.
11.3 Configuring IPv4/IPv6 Dual Stacks
To establish an IPv6 over IPv4 tunnel, you need to configure both the IPv4 protocol suite and
the IPv6 protocol suite on the devices where an IPv4 network borders an IPv6 network.
11.4 Configuring an IPv6 over IPv4 Tunnel
You can interconnect IPv6 networks by using IPv4 networks.
11.5 Configuring 6PE
By performing this configuration task, you can interconnect IPv6 networks through the existing
MPLS network.
11.6 Maintaining IPv6 over IPv4 Tunnels
This section describes how to maintain an IPv6 over IPv4 tunnel, including how to monitor an
IPv6 over IPv4 tunnel.
11.7 Configuration Examples
This section provides configuration examples of IPv6 over IPv4 tunnel.
Issue 01 (2012-03-15)

IPv6 over IPv4 Tunnel Configuration

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
182