No Ip Dhcp-Server; Ip Dhcp-Server Icmp-Probe - Siemens SCALANCE XM-400 Configuration Manual

7.5.2.2

no ip dhcp-server

Description
With this command, you disable the DHCP server on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the
7.5.2.3

ip dhcp-server icmp-probe

Description
With this command you enable the function "Probe address with ICMP echo before offer".
The DHCP server checks whether or not the IPv4 address has already been assigned. If no
reply is received, the DHCP server can assign the IPv4 address.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server icmp-probe
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ip dhcp-server
Network protocols
7.5 DHCP server
349