Show Dcp Forwarding - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call the command without parameters:
show dcp server
Result
The overview of the status of the DCP function and access rights is displayed.
7.1.1.6

show dcp forwarding

Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The overview of the DCP forwarding behavior is displayed.
288
or
cli#
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11