Link Layer Discovery Protocol (Lldp) Commands - D-Link DGS-1510 Series Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
43. Link Layer Discovery Protocol (LLDP)
Commands
43-1 clear lldp counters
This command is used to delete LLDP statistics.
clear lldp counters [all | interface INTERFACE-ID [, | -]]
Parameters
all
interface INTERFACE-ID
,
-
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command with the interface keyword to reset LLDP statistics of the specified interface(s). If
the command clear lldp counters is issued with the all keyword to clear global LLDP statistics and
the LLDP statistics on all interfaces. When no optional keyword is selected, only the LLDP global
counters will be cleared.
Example
This example shows how to clear all LLDP statistics.
Switch# clear lldp counters all
Switch#
43-2 clear lldp table
This command is used to delete all LLDP information learned from neighboring devices.
clear lldp table {all | interface INTERFACE-ID [, | -]}
Parameters
all
INTERFACE-ID
,
Specifies to clear LLDP counter information for all interfaces and
global LLDP statistics.
Specifies the interface to clear LLDP counter information.
(Optional) Specifies a series of physical interfaces. No spaces
before and after the comma.
(Optional) Specifies a range of physical interfaces. No spaces
before and after the hyphen.
Specifies to clear LLDP neighboring information for all interfaces.
Specifies the interface's ID.
(Optional) Specifies a series of physical interfaces. No spaces
352