Table of Contents
Advertisement
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - Network Management
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End
6.5.3 Checking the Configuration
After configuring the FTP upload test, you can view the test result.
Prerequisites
The configurations of the FTP Upload Test function are complete.
Context
Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Huawei> display nqa results
NQA entry(admin, ftp) :testflag is inactive ,testtype is ftp
1 . Test 1 result
6.6 Configuring the HTTP Test
This section describes how to configure a Hypertext Transfer Protocol (HTTP) test to check the
responding speed of the HTTP service in each phase.
Issue 02 (2012-03-30)
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
CtrlConnTime
DataConnTime
SumTime
The test is finished
SendProbe:1
Completion :success
MessageBodyOctetsSum: 448
Operation timeout number: 0
Drop operation number:0
CtrlConnTime Min/Max/Average: 438/438/438
DataConnTime Min/Max/Average: 218/218/218
SumTime Min/Max/Average: 656/656/656
Average RTT:380
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
ResponseProbe:1
RTD OverThresholds number: 0
Stats errors number: 0
System busy operation number:0
Disconnect operation number: 0
154
Advertisement
Table of Contents
