Optional) Closing A Connection; Checking The Configuration; Configuring Rs-Dcc - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - WAN

1.6.1.7 (Optional) Closing a Connection

Context
To reduce network loads or adjust dialing configurations, you may need to tear down a dial-up
link using command.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dialer disconnect [ interface interface-type interface-number ]
A dial-up link is torn down.
After a dial-up link is torn down, all services on the link are interrupted; therefore, ensure that
the link is not in use before you tear down the link.
This command only temporarily tears down dial-up links.
l If a disconnected link is enabled with the auto-dial function, it will be re-established when
l If the link is not enabled with the auto-dial function, it will be re-established when data needs
----End

1.6.1.8 Checking the Configuration

Prerequisites
All configurations of C-DCC are complete.
Procedure
Step 1 Run the display dialer [ interface interface-type interface-number ] command to check DCC
information on the dialup interface.
Step 2 Run the display interface dialer [ number ] command to check information about the dialer
interface.
----End

1.6.2 Configuring RS-DCC

A physical interface in RS-DCC can belong to multiple dialer bundles and serves multiple dialer
interfaces. A dialer interface is bound to only one destination and uses only one dialer bundle.
A dialer bundle can contain multiple physical interfaces that have different priorities.
Issue 01 (2014-11-30)
the dialer timer expires.
to be transmitted over it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 DCC Configuration
22