Sending Trap Messages When The Transmission Delay Exceeds Thresholds; Checking The Configuration - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
Sending trap messages when tests are completed is enabled.
By default, the trap function is disabled.
----End
6.17.5 Sending Trap Messages When the Transmission Delay
Exceeds Thresholds
A trap message is sent to the NMS when the test result exceeds the threshold.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type { jitter }
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
send-trap rtd
Sending trap messages when the transmission delay exceeds the threshold is enabled.
By default, the trap function is disabled.
----End

6.17.6 Checking the Configuration

After the trap function is enabled in an NQA test instance, you can view trap messages in the
trap buffer.
Prerequisite
The configurations of the Trap function are complete.
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
301