Configuring And Starting The Nap Master Interface - Huawei netengine80e Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - Basic Configurations
Data Preparation
To configure NAP-based remote deployment, you need the following data.
No.
1
2

10.13.2 Configuring and Starting the NAP Master Interface

You can assign an IP address to the NAP master interface or use the IP address that is
automatically allocated by the system to start the NAP master interface.
Context
If commands affecting the IP address configuration or IP packet forwarding (such as
configurations and commands related to the VPN, Eth-Trunk, IP-Tunk, or Layer 2 interface)
exist on device of the master interface, NAP enabled on the master interface becomes
unavailable. You are recommended to delete these commands and re-enable NAP.
Do as follows on the router to configure and start the NAP master interface.
In NAP, IP addresses can be allocated either automatically or manually.
Procedure
l
Issue 02 (2011-09-10)
NOTE
l If the IP addresses used for establishing NAP connections are to be manually configured, you need to
prepare the following data before configuring NAP.
l Conversely, if the IP addresses for establishing NAP connections are to be automatically configured,
you can skip this.
Data
Two primary IP addresses. The two IP addresses are primary IP addresses for the
master interface and the slave interface respectively, and should be on the same
network segment.
Two secondary IP addresses. The two IP addresses are secondary IP addresses for
the master interface and the slave interface respectively, and should be on the same
network segment.
CAUTION
Automatic allocation of IP addresses
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Device Maintenance
283