Configuring Acl Control Over The Snmp Users; Defining Acl - Huawei Quidway S3500 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches
II. Networking diagram
Internet
Switch
Figure 3-1 Control TELNET users with ACL
III. Configuration procedure
# Define the basic ACLs.
[Quidway] acl number 2020 match-order config
[Quidway-acl-basic-2020] rule 1 permit source 10.110.100.52 0
[Quidway-acl-basic-2020] rule 2 permit source 10.110.100.46 0
[Quidway-acl-basic-2020] quit
# Call an ACL.
[Quidway] user-interface vty 0 4
[Quidway-user-interface-vty0-4] acl 2020 inbound

3.3 Configuring ACL Control over the SNMP Users

Huawei Quidway Ethernet switch series support the remote management with the
network management software. The network management users can access the
switch with SNMP. Controlling such users with ACL can help filter the illegal NM users
and prevent them from accessing the local switch.
Take the following steps to control the SNMP users with ACL.
1)

Defining ACL

2) Calling ACL to control SNMP users
The follow section introduces the configuration procedures.
3.3.1 Defining ACL
You can only call the numbered basic ACL, ranging from 2000 to 2999, to implement
ACL control function. Use the same configuration commands introduced in the last
section.
Chapter 3 Logon User ACL Control Configuration
Huawei Technologies Proprietary
3-3