Configuring The Snmp Query Test; Establishing The Configuration Task - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the statistics about each hop are displayed, it means
that the traceroute test is successful.
<Quidway> display nqa results
NQA entry(t, t) :testflag is inactive ,testtype is trace
1 . Test 1 result

6.11 Configuring the SNMP Query Test

This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.

6.11.1 Establishing the Configuration Task

Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l
l
Data Preparation
To configure the SNMP query test, you need the following data.
Issue 01 (2011-07-15)
The test is finished
Completion:success
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
Configuring the SNMP agent
Configuring routes between the NQA client and the SNMP agent
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Attempts number:1
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Receive response times: 3
6 NQA Configuration
276