Snmp Config - Siemens SCALANCE X-200 Configuration Manual

Menus in the WBM
5.3 The Agent menu
5.3.3

SNMP Config

Note
On X-200IRT IE switches with firmware versions V4.0 and lower only the SNMPv1/v2 mode
is possible.
Agent SNMP Configuration - Configuration of SNMP for an IE Switch X-200
On the SNMP Agent Configuration page, you make basic settings for SNMP. For detailed
settings (traps, groups, users), there are separate menu commands in WBM.
Figure 5-17
SNMP enabled
Here, you can decide whether only SNMPv3 or also SNMPv1/v2 can be used.
SNMP Read Only
Enables/disables write protection for SNMP variables.
SNMP Community Strings
Read Community String
Displays the user name for read access to SNMP variables.
Write Community String
Displays the user name for write access to SNMP variables. Here, changes can only be
made, when write protection (SNMP read only) has been disabled.
Traps
Here, you can enable or disable the sending of SNMP traps.
84
Agent SNMP Configuration
Configuration Manual, 03/2015, C79000-G8976-C285-06
SCALANCE X-200