Result
The ID of the guest VLAN has the value 1.
11.7.5.5
dot1x guest-vlan reset
Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC
address, only this MAC address is removed from the guest VLAN. If you use this command
without parameters, all MAC addresses are removed from the guest VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter
mac
aa:aa:aa:aa:aa:aa
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest
VLAN.
11.7.5.6
set dot1x guest-vlan mac-addr count
Description
With this command, you specify how many end devices are allowed to be connected to the
port at the same time.
Requirement
You are in the Interface configuration mode.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Keyword for the MAC address
MAC address to be removed from the
guest VLAN.
Security and authentication
11.7 Port Based Network Access Control
Range of values
-
-
533