Select/Set Button; Position; Function - Siemens SIMATIC NET SCALANCE XC-300 Operating Instructions Manual

Description of the device

4.8 SELECT/SET button

4.8 SELECT/SET button
4.8.1

Position

The "SELECT/SET" button is located on the front of the device.
Figure 4-6
4.8.2

Function

The device has a button with the following functions:
• Reset the device to default settings
Please note that the button function distinguishes between the startup phase and running
operation.
For more information, refer to "Resetting the device to default settings with the button (in the
startup phase) (Page 71)" and "Resetting the device to default settings with the button
(during operation) (Page 72)".
• Load a firmware file via TFTP
For more information, refer to "Loading a firmware file via TFTP (Page 73)".
• Setting the display mode
The display mode is used for diagnostics of the device. Depending on the set display mode,
the LEDs of the device show different information and indicate the state of the device.
For more information, refer to "Setting the display mode (Page 39)".
For more information on the display modes, refer to "LEDs "DM1" and "DM2" (Page 34)".
38
Position of the "SELECT/SET" button using the example of a SCALANCE XC-300
Operating Instructions, 10/2022, C79000-G8976-C584-01
SCALANCE XC-300