9.3.13.24
no distribute-list route-map
Description
This command disables the filtering of the routing information according to a route map for
incoming routing information.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(1-20)> in
The parameters have the following meaning:
Parameter
name
in
Result
The filtering is disabled.
9.3.13.25
router id
Description
With this command, you specify the ID of the router.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Name of the routing table.
Incoming routing information is filtered.
Layer 3 functions
9.3 OSPFv2
Values
Maximum of 20 characters.
-
395