Spanning-Tree Mst Instance-Id Root - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call the command without parameters:
spanning-tree mst configuration
Result
You are now in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
Further notes
You exit the MSTP configuration mode with the end or exit command.
6.3.4.6

spanning-tree mst instance-id root

Description
With this command you specify whether the device is a root bridge (primary) or a substitute
root bridge (secondary).
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst{instance-id<instance-id(1-64)>}root{primary|
secondary}
The parameters have the following meaning:
Parameter
instance-
id
instance-
id
232
Description
Keyword for the instance
Number of the instance
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 64
Configuration Manual, 07/2017, C79000-G8976-C361-06