No Ip Single-Hop Inter-Vlan-Routing - Siemens SCALANCE XC-200 Configuration Manual

cli(config)#
Syntax
Call the command without parameters:
ip single-hop inter-vlan-routing
Result
The function is enabled. The device can route between two local IP interfaces.
Further notes
You disable the Single-Hop Inter-VLAN-Routing function with the no ip single-hop
inter-vlan-routing command.
9.2.1.2

no ip single-hop inter-vlan-routing

Description
With this command, you enable the Single-Hop Inter-VLAN-Routing function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip single-hop inter-vlan-routing
Result
The function is disabled.
Further notes
You enable the Single-Hop Inter-VLAN-Routing function with the ip single-hop inter-
vlan-routing command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Layer 3 functions
9.2 Single-Hop Inter-VLAN-Routing
451