Network protocols
7.1 IPv4 protocol
7.1.11.4
no ip routing
Description
With this command, you disable the routing function.
Note
This command is available only with layer 3.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip routing
Result
The routing function is disabled.
Further notes
You enable the function with the
You display the setting with the
7.1.11.5
ip echo-reply
Description
To check the availability of a network node, packets of the Internet Control Message Protocol
(ICMP) can be sent to it. These packets of type 8 request the recipient to send a packet back
to the sender (echo reply).
With this command, you enable the ICMP echo reply messages.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
242
command.
ip routing
command.
show ip route
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07