No Sntp Unicast-Server Ipv4 - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call up the command with the following parameters:
sntp unicast-server ipv4 <ucast_addr> [port<1025-36564>]
[poll<seconds(16-16284)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
port
poll
seconds
Result
The SNTP unicast server is configured.
Further notes
You can reset the setting to the default with the no sntp unicast-server ipv4 command.
You display this setting and other information with the show sntp unicast–mode
status command.
5.3.3.4

no sntp unicast-server ipv4

Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server ipv4<ucast_addr>
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Keyword for an IP address
Value for an IPv4 unicast address
UDP port of the time server
Keyword for the time after which the
time of day is requested again
Value for the time in seconds
System time
5.3 SNTP client
Range of values / note
-
Enter a valid IPv4 unicast address.
1025 ... 36564
Default: 123
-
16 ... 16284
159