Subaru Legacy 2005 Service Manual page 1944

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK ELECTRONIC THROTTLE CON-
TROL RELAY.
1) Turn the ignition switch to OFF.
2) Remove the electronic throttle control relay.
3) Measure the resistance between electronic
throttle control relay terminals.
Terminal
No. 7 — No. 8:
2 CHECK POWER SUPPLY SHORT CIRCUIT
OF ELECTRONIC THROTTLE CONTROL
RELAY.
1) Turn the ignition switch to ON.
2) Measure the voltage between electronic
throttle control relay connector and chassis
ground.
Connector & terminal
(B362) No. 7 (+) — Chassis ground (
3 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL RE-
LAY.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ECM.
3) Measure the resistance between ECM con-
nector and chassis ground.
Connector & terminal
(B135) No. 35 — Chassis ground:
CX:DTC P2109 THROTTLE/PEDAL POSITION SENSOR "A" MINIMUM STOP
PERFORMANCE
NOTE:
For diagnostic procedure, refer to DTC P2101. <Ref. to EN(H6DO)(diag)-239, DTC P2101 THROTTLE AC-
TUATOR CONTROL MOTOR CIRCUIT RANGE/PERFORMANCE, Diagnostic Procedure with Diagnostic
Trouble Code (DTC).>
Check
Is the resistance more than 1
MΩ?
Is the voltage more than 5 V?
−
):
Is the resistance more than 1
MΩ?
EN(H6DO)(diag)-248
Yes
Go to step 2. Replace the elec-
tronic throttle con-
trol relay.
Go to step 3. Repair the power
supply short cir-
cuit of harness
between ECM and
electronic throttle
control relay.
Repair the poor Repair the ground
contact in ECM short circuit of har-
connector. ness between
Replace the ECM ECM and elec-
if defective. <Ref. tronic throttle con-
to FU(H6DO)-34, trol relay.
Engine Control
Module (ECM).>
No