Honda ACCORD HYBRID 2005 Service Manual page 52

Starting System
S t a r t e r C i r c u i t T r o u b l e s h o o t i n g ( c o n t ' d )
16. Remove the j u m p e r w i r e .
17. Measure the voltage between starter cut relay 4P
socket terminal No. 3 and body g r o u n d w i t h the
ignition switch turned to START (ill).
S T A R T E R C U T R E L A Y 4P S O C K E T
Terminal side of f e m a l e t e r m i n a l s
Is there battery voltage?
Y E S — G o t o step 18.
NO—Replace the under-dash fuse/relay b o x . B
18. Reinstall the starter cut relay.
19. Turn the ignition switch ON (II), and j u m p the SCS
line w i t h the HDS, then turn the ignition switch OFF.
NOTE: This must be done to protect the PCM f r o m
damage.
20. Disconnect PCM connector E (31P).
21. Measure the voltage between PCM connector
terminal E1 and body g r o u n d w i t h the ignition
switch turned to START (III).
PCM C O N N E C T O R E (31P)
S T C (PNK)
1 2 3 4 5 6
7
8 9
10 11 12 13 14 15 16 17 18 19 20 21
22 23 24 25 26 27
/
29
/
31
W i r e side of f e m a l e t e r m i n a l s
Is there battery voltage?
Y E S — G o to step 22.
NO—Check for an open in the PNK w i r e between
the under-dash fuse/relay box and the PCM. If the
wire is OK, replace the under-dash fuse/relay
box. •
4-8