Qspi Wrap Register (Qwr); Qdlyr Field Descriptions; Qwr Field Descriptions - Motorola ColdFire MCF5281 User Manual

Programming Model
Table 22-5 gives QDLYR field descriptions.
Bits Name
15 SPE QSPI enable. When set, the QSPI initiates transfers in master mode by executing commands in the command
RAM. Automatically cleared by the QSPI when a transfer completes. The user can also clear this bit to abort
transfer unless QIR[ABRTL] is set. The recommended method for aborting transfers is to set QWR[HALT].
14–8 QCD QSPICLK delay. When the DSCK bit in the command RAM is set this field determines the length of the delay
from assertion of the chip selects to valid QSPI_CLK transition.
7–0 DTL Delay after transfer. When the DT bit in the command RAM is set this field determines the length of delay
after the serial transfer.

22.5.3 QSPI Wrap Register (QWR)

15 14
Field HALT WREN WRTO CSIV
Reset
R/W
Address
Table 22-6 gives QWR field descriptions.
Bits Name
15 HALT Halt transfers. Assertion of this bit causes the QSPI to stop execution of commands once it has completed
execution of the current command.
14 WREN Wraparound enable. Enables wraparound mode.
0 Execution stops after executing the command pointed to by QWR[ENDQP].
1 After executing command pointed to by QWR[ENDQP], wrap back to entry zero, or the entry pointed
to by QWR[NEWQP] and continue execution.
13 WRTO Wraparound location. Determines where the QSPI wraps to in wraparound mode.
0 Wrap to RAM entry zero.
1 Wrap to RAM entry pointed to by QWR[NEWQP].
12 CSIV QSPI_CS inactive level.
0 QSPI chip select outputs return to zero when not driven from the value in the current command RAM
entry during a transfer (that is, inactive state is 0, chip selects are active high).
1 QSPI chip select outputs return to one when not driven from the value in the current command RAM
entry during a transfer (that is, inactive state is 1, chip selects are active low).
11–8 ENDQP End of queue pointer. Points to the RAM entry that contains the last transfer description in the queue.
7–4 CPTQP Completed queue entry pointer. Points to the RAM entry that contains the last command to have been
completed. This field is read only.
3–0 NEWQP Start of queue pointer. This 4-bit field points to the first entry in the RAM to be executed on initiating a
transfer.
22-12
Table 22-5. QDLYR Field Descriptions
13 12 11
ENDQP
R/W
Figure 22-6. QSPI Wrap Register (QWR)
Table 22-6. QWR Field Descriptions
MCF5282 User's Manual
Description
8 7
CPTQP
0000_0000_0000_0000
IPSBAR + 0x348
Description
4 3
NEWQP
R R/W
MOTOROLA
0