Csr Field Descriptions - Motorola ColdFire MCF5281 User Manual

Table 29-8 describes CSR fields.
Bit Name
31–28 BSTAT Breakpoint status. Provides read-only status information concerning hardware breakpoints. BSTAT is
cleared by a TDR write or by a CSR read when either a level-2 breakpoint is triggered or a level-1
breakpoint is triggered and the level-2 breakpoint is disabled.
0000 No breakpoints enabled
0001 Waiting for level-1 breakpoint
0010 Level-1 breakpoint triggered
0101 Waiting for level-2 breakpoint
0110 Level-2 breakpoint triggered
27 FOF Fault-on-fault. If FOF is set, a catastrophic halt occurred and forced entry into BDM. FOF is cleared
whenever CSR is read.
26 TRG Hardware breakpoint trigger. If TRG is set, a hardware breakpoint halted the processor core and forced entry
into BDM. Reset, the debug
25 HALT Processor halt. If HALT is set, the processor executed a HALT and forced entry into BDM. Reset, the debug
command, or reading CSR will clear HALT.
GO
24 BKPT Breakpoint assert. If BKPT is set, BKPT was asserted, forcing the processor into BDM. Reset, the debug
command, or reading CSR will clear BKPT.
23–20 HRL Hardware revision level. Indicates the level of debug module functionality. An emulator could use this
information to identify the level of functionality supported.
0000 Initial debug functionality (Revision A) (This is the only valid value for the MCF5282.)
19–17 — Reserved, should be cleared.
16 IPW Inhibit processor writes. Setting IPW inhibits processor-initiated writes to the debug module's programming
model registers. IPW can be modified only by commands from the external development system.
15 MAP Force processor references in emulator mode.
0 All emulator-mode references are mapped into supervisor code and data spaces.
1 The processor maps all references while in emulator mode to a special address space, TT = 10, TM = 101
or 110.
14 TRC Force emulation mode on trace exception. If TRC = 1, the processor enters emulator mode when a trace
exception occurs. If TRC=0, the processor enters supervisor mode.
13 EMU Force emulation mode. If EMU = 1, the processor begins executing in emulator mode. See Section 29.6.1.1,
"Emulator Mode."
12–11 DDC Debug data control. Controls operand data capture for DDATA, which displays the number of bytes defined
by the operand reference size before the actual data; byte displays 8 bits, word displays 16 bits, and long
displays 32 bits (one nibble at a time across multiple PSTCLK cycles). See Table 29-2.
00 No operand data is displayed.
01 Capture all write data.
10 Capture all read data.
11 Capture all read and write data.
10 UHE User halt enable. Selects the CPU privilege level required to execute the HALT instruction.
0 HALT is a supervisor-only instruction.
1 HALT is a supervisor/user instruction.
9–8 BTB Branch target bytes. Defines the number of bytes of branch target address DDATA displays.
00 0 bytes
01 Lower 2 bytes of the target address
10 Lower 3 bytes of the target address
11 Entire 4-byte target address
See Section 29.3.1, "Begin Execution of Taken Branch (PST = 0x5)."
MOTOROLA
Table 29-8. CSR Field Descriptions
Description
command, or reading CSR will clear TRG.
GO
Chapter 29. Debug Support
Programming Model
GO
29-11