Table of Contents
Advertisement
Chapter 7: GTP Receiver (RX)
Table 7-2
the GTP_DUAL tile.
Table 7-2: RX Termination and Equalization Attributes
Attribute
AC_CAP_DIS_0
AC_CAP_DIS_1
RCV_TERM_GND_0
RCV_TERM_GND_1
RCV_TERM_MID_0
RCV_TERM_MID_1
RCV_TERM_VTTRX_0
RCV_TERM_VTTRX_1
TERMINATION_IMP_0
TERMINATION_IMP_1
Description
The GTP_DUAL receivers are connected via differential pad pairs RXN and RXP to the
transmission line on the board.
receiver channel inside the GTP_DUAL block.
126
describes the attributes and settings regarding termination for both receivers of
Bypasses the built-in AC coupling in the receiver. Use this attribute when DC coupling is
required.
TRUE: Built-in AC coupling capacitors are bypassed. DC coupling to the receiver is
possible.
FALSE: Built-in AC coupling capacitors are enabled. This is the default setting for this
parameter.
See
Chapter 10, "GTP-to-Board Interface,"
an additional external capacitor for AC coupling.
Activates the Ground reference for the receiver termination network.
TRUE: Ground reference for receiver termination activated.
FALSE: Ground reference for receiver termination disabled.
See
Table 7-3, page 128
for valid combinations of RX termination attributes.
Activates the 2/3 AVTTRX reference for the termination circuit after the built-in AC
coupling circuit in the receiver. RCV_TERM_MID should always be set to !AC_CAP_DIS.
TRUE: 2/3 AVTTRX reference after built-in AC coupling is activated.
FALSE: 2/3 AVTTRX reference after built-in AC coupling is disabled.
Activates AVTTRX reference for receiver termination network.
TRUE: AVTTRX reference for receiver termination activated.
FALSE: AVTTRX reference for receiver termination disabled.
See
Table 7-3, page 128
for valid combinations of RX termination attributes.
Selects the termination impedance for the TX driver and RX CML receiver.
See
Chapter 10, "GTP-to-Board Interface,"
Always set to 50, to select 50Ω termination impedance.
www.xilinx.com
Description
for details about when it is appropriate to add
for details on calibration of impedance values.
Figure 7-2
illustrates the internal architecture of one
Virtex-5 RocketIO GTP Transceiver User Guide
R
UG196 (v1.3) May 25, 2007
Advertisement
Table of Contents
