Xilinx Virtex-5 RocketIO GTP User Manual page 121

R
(see
channel is set to either 1 (for a 3.0 Gb/s SATA2 rate) or 2 (for a 1.5 Gb/s SATA1 rate).
Note:
GTP_DUAL Dynamic Reconfiguration port (see
be used to change the appropriate PLL_TXDIVSEL_OUT attribute. The COM sequence timing is
adjusted automatically.
When a TXCOMSTART operation completes, RXSTATUS[0] is driven High for one
RXUSRCLK2 cycle. Be careful not to use the output of RXSTATUS[0] without
synchronizing it to the TXUSRCLK2 domain if TXUSRCLK2 and RXUSRCLK2 are driven
by separate clocks.
Virtex-5 RocketIO GTP Transceiver User Guide
UG196 (v1.3) May 25, 2007
"Shared PMA PLL," page
If the SATA rate needs to be changed at run time (e.g. for SATA autonegotiation), the
www.xilinx.com
60) is set to 1.5 GHz, and PLL_TXDIVSEL_OUT for each
"Dynamic Reconfiguration Port (DRP)," page
TX OOB/Beacon Signaling
87) can
121