Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-address 2001::1 ff1e::/64
ipv6 pimsm rp-candidate
Use the ipv6 pimsm rp-candidate command to configure the router to advertise itself as a PIM
candidate rendezvous point (RP) to the bootstrap router (BSR). Use the "no" form of this
command to disable the router from advertising itself as a PIM candidate rendezvous point (RP)
to the bootstrap router (BSR).
Syntax
ipv6 pimsm rp-candidate vlan
no ipv6 pimsm rp-candidate vlan
•
vlan-id—A valid VLAN ID value.
•
group-address— The group address to display.
•
prefixlength— This parameter specifies the prefix length of the IP address for the media
gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-candidate vlan 6 ff1e::/64
vlan-id group-address/prefixlength
vlan-id
IPv6 Multicast Commands
647