Ipv6 Characteristics - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
igmp—Configures an IGMP interface
ignore-df-bit—Specifies that the don't-fragment bit is ignored
inactivity-timer—Configures an inactivity timer value for IP interfaces
inspection—Associates an inspection list to the interface for firewalling
mtu—Configures the MTU for a network
nat—Configures the interface as inside or outside for Network Address Translation
(NAT)
policy—Assigns a policy to the ingress or egress of an interface
redirects—Enables transmission of ICMP redirect messages
route-cache flow sampled—Enables J-Flow statistics on an interface
route-map ip-subscriber—Configures the interface for route-map processing
sa-validate—Verifies that a packet has been sent from a valid source address
tcp adjust-mss—Modifies maximum segment size (MSS) on TCP connections when
path MTU detection is not sufficient
unnumbered—Configures IP on this interface without a specific address
virtual-router—Specifies a virtual router (VR) to which interfaces created by this profile
attach

IPv6 Characteristics

A profile can contain one or more of the following IPv6 characteristics:
address—Configures an IPv6 address on an interface
http—Configures the HTTP local server for IPv6
http redirectUrl—Configures the URL to which a subscriber's initial Web browser session
is redirected
nd—Enables Neighbor Discovery on an interface
nd managed-config-flag—Sets the "managed address configuration" flag in IPv6 router
advertisements
nd other-config-flag—Sets the "other stateful configuration" flag in IPv6 router
advertisements
nd prefix-advertisement—Specifies which IPv6 prefixes are included in IPv6 router
advertisements
nd ra-interval—Configures the interval between IPv6 router advertisements
nd ra-lifetime—Configures the router advertisement lifetime
nd reachable-time—Configures the amount of time the router can reach an IPv6 node
after a reachability confirmation event occurs
nd suppress-ra—Disables router advertisement transmissions
Chapter 17: Configuring Dynamic Interfaces
561

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents