Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 109

show atm map
Copyright © 2010, Juniper Networks, Inc.
InCellErrors: 0
qos-mode-port disabled
queue 0: traffic class control, bound to ATM2/0
Forwarded packets 643, Bytes 36008
Dropped committed packets 0, Bytes 0
Dropped conformed packets 0, Bytes 0
Dropped exceeded packets 0, Bytes 0
Example 2—Shows a summary of all ATM interfaces
host1#show atm interface brief
Interface Status
--------- --------------
ATM 2/0 up
ATM 2/1 up
ATM 2/2 lowerLayerDown
ATM 2/3 down
ATM 4/0 up
ATM 6/0 lowerLayerDown
See show atm interface.
See show interfaces.
Use to display the list of all configured ATM static maps to remote hosts on an ATM
network.
Field descriptions
Map list—Name of map list and method used to enter the map list. PERMANENT
indicates that the map entry was configured; it was not entered automatically by a
process.
protocol address maps to VCx—Name of protocol, the protocol address, and the
VCD that the address is mapped to (for ATM VCs configured with the atm pvc
command).
VC—Number of the virtual circuit
broadcast—Indicates pseudo-broadcasting
connection up—Indicates a point-to-point virtual circuit
Example 1
host1#show atm map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0
ip 192.168.2.30 maps to VC 12 atm 2/0
Map list other-map : PERMANENT
ip 192.10.2.10 maps to VC 100 atm 2/1
ip 192.10.2.20 maps to VC 101 atm 2/1
ip 192.10.2.30 maps to VC 102 atm 2/1
Example 2
Chapter 1: Configuring ATM
Configured
VCs
----------
2
3
4
5
2
2
broadcast
broadcast
77