Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 729

Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
PPP Peer WINS Priority—Enabled or disabled
PPP Authentication—Type of authentication configured: PAP, CHAP, or none
PPP Authentication Router—Name of authentication virtual router
PPP Negotiate MRU—MRU configured for the profile
PPP Packet Log—Enabled or disabled
PPP State Log—Enabled or disabled
PPP Chap Challenge Length—Minimum and maximum Chap Challenge length
PPP Passive Mode—Enabled or disabled
PPP Multilink—Enabled or disabled
PPP IPCP netmask option—Enabled or disabled
PPP AAA Profile—AAA profile associated with this PPP interface
PPP Multilink Fragmentation—Enabled or disabled
PPP Multilink Fragment Size—Multilink fragment size for this PPP interface
PPP Multilink Reassembly—Enabled or disabled
PPP Multilink Mrru—Multilink MRRU value for this PPP interface
PPP Initiate IP—Initiation of IPv4 over this PPP interface; enabled or disabled
PPP Initiate IPv6—Initiation of IPv6 over this PPP interface; enabled or disabled
PPPoE Max Sessions—Maximum number of PPPoE subinterfaces that can be on an
interface
PPPoE Always-offer—Router offers to set up a session for the client, even if the
router has insufficient resources to establish a session; enabled or disabled
PPPoE Remote-Circuit-Id—Router captures and processes a vendor-specific tag
containing a remote circuit ID transmitted from a digital subscriber line access
multiplexer (DSLAM); enabled or disabled
PPPoE Log PPPoeControlPacket—Enabled or disabled
PPPoE duplicate-protect—Enabled or disabled
PPPoE ACNAME—Access concentrator name
PPPoE URL—URL sent in PADM message to PPPoE clients
PPPoE MOTM—Message of the minute sent in the PADM message to PPPoE clients
PPPoE Service-Name Table—Name of the PPPoE service name table, if configured
for the specified profile
Copyright © 2010, Juniper Networks, Inc. 697