Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 374

JunosE 11.3.x Link Layer Configuration Guide
show ppp interface summary
342
peer-primary-dns-address
peer-secondary-dns-address
peer-primary-wins-address
peer-secondary-wins-address
peer-ipv6-interface-id
See show ppp interface.
Use to display a summary of all the multilinked and nonmultilinked PPP interfaces
configured on the router.
Field descriptions
PPP Status—Non-multilinked PPP interfaces
Configuration status—Indicates the configuration state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
configured—Interface or protocol is configured
notConfigured—Interface or protocol is not configured
Administrative status—Indicates the administrative state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
open—Interface or protocol is administratively enabled
closed—Interface or protocol is administratively disabled
Operational status (Interface)—Indicates the operational state of the PPP interface
up—Interface is operational
down—Interface is not operational because of a problem in the PPP layer
lowerDown—Interface is not operational because a lower layer in the protocol
stack is down
notPresent—Interface is not operational because the hardware is unavailable
passive—Interface is waiting for the peer to send an LCP confReq message
tunnel—Interface is being redirected through a tunnel
Operational status (Ip, Ipv6, Osi, Mpls)—Indicates the operational state of the IPCP,
IPv6CP, OSINLCP, or MPLS protocol
up—Protocol is operational
down—Protocol is not operational because of a problem in the PPP layer
none
none
none
none
none
Copyright © 2010, Juniper Networks, Inc.