Table of Contents
Advertisement
JunosE 11.3.x Link Layer Configuration Guide
Working with Profiles
564
remote-circuit-id—Enables the router to capture and process a vendor-specific tag
containing a remote circuit ID transmitted from a digital subscriber line access
multiplexer (DSLAM) device
service-name-table—Assigns a PPPoE service name table to dynamic interfaces
created with this profile
sessions—Specifies the maximum number of subinterfaces permitted on a PPPoE
major interface
url—Causes the PPPoE application to send a URL string to the new client
VLAN Characteristics
A profile can contain one or more of the following VLAN characteristics:
advisory-rx-speed—Sets an advisory receive speed for VLAN subinterfaces
advisory-tx-speed—Sets an advisory connect speed for VLAN subinterfaces
auto-configure—Specifies the types of upper-interface encapsulations that are
accepted or detected by the dynamic VLAN subinterface
auto-configure agent-circuit-identifier—Enables the creation of VLAN subinterfaces
that are based on agent-circuit-identifier information
description—Assigns a description to VLAN subinterfaces that are created with this
profile
policy—Attaches (or removes) a policy to (or from) a dynamically created VLAN
profile—Adds a nested profile assignment, which references another profile that
dynamically configures an upper-interface encapsulation type over the VLAN
subinterface
service-profile—Specifies a service profile name to a dynamically created VLAN
svlan ethertype—Specifies that the packet must use this Ethertype to create the
dynamic VLAN subinterface
Figure 56 on page 564 shows how to create a profile and assign characteristics to it.
Figure 56: Creating and Configuring a Profile
Figure 57 on page 565 shows how to assign a profile to static interfaces. These static
interfaces create dynamic interfaces above them.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
