Monitoring Pppoe - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Monitoring PPPoE

Copyright © 2010, Juniper Networks, Inc.
RADIUS overrides the standard use of the Calling-Station-Id [31] or NAS-Port-Id [87]
attribute with the PPPoE remote circuit ID only if the DSLAM transmits non-empty
data for at least one of the agent-circuit-id or agent-remote-id values. If the DSLAM
transmits empty data, then RADIUS does not override the Calling-Station-Id [31] or
NAS-Port-Id [87] RADIUS attribute with the PPPoE remote circuit ID and instead uses
the standard value for the RADIUS attribute.
If a single component in a multi-component PPPoE remote circuit ID format is empty,
the router represents the empty component as two consecutive delimiter characters
(## by default).
Example 1—Formats the PPPoE remote circuit ID value to include only the
agent-remote-id suboption of the tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format agent-remote-id
Example 2—Formats the PPPoE remote circuit ID value to include both the
agent-circuit-id and agent-remote-id suboptions of the tags supplied by the PPPoE
intermediate agent.
host1(config)#radius remote-circuit-id-format agent-circuit-id agent-remote-id
Example 3—Formats the PPPoE remote circuit ID value to include the NAS-Identifier
[32] RADIUS attribute with the agent-circuit-id suboption of the tags supplied by the
PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
Example 4—Formats the PPPoE remote circuit ID value to include the NAS-Identifier
[32] RADIUS attribute with the agent-remote-id suboption of the tags supplied by the
PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-remote-id
Example 5—Formats the PPPoE remote circuit ID value to include the NAS-Identifier
[32] RADIUS attribute with both the agent-circuit-id and agent-remote-id suboptions
of the tags supplied by the PPPoE intermediate agent.
host1(config)#radius remote-circuit-id-format nas-identifier agent-circuit-id
agent-remote-id
Example 6—Formats the PPPoE remote circuit ID value to use the format for the
dsl-forum-1 keyword. For details about how the router implements this format, see
"Format for dsl-forum-1 Keyword" on page 377.
host1(config)#radius remote-circuit-id-format dsl-forum-1
Use the no version to restore the default format, agent-circuit-id.
See radius remote-circuit-id-format.
Use the commands described in this section to display information about PPPoE interfaces
and subinterfaces.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
419