Sending Interface Descriptions To Aaa - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

atm aal5 description
atm atm1483 description
atm description

Sending Interface Descriptions to AAA

Copyright © 2010, Juniper Networks, Inc.
Use to assign a text description or alias to an ATM AAL5 interface.
Use the show atm aal5 interface command to display the text description.
Example
host1(config-if)#atm aal5 description boston01
Use the no version to remove the text description or alias.
See atm aal5 description.
Use to assign a text description or alias to an ATM 1483 subinterface.
The description can be a maximum of 255 characters.
Use the show atm subinterface command to display the text description.
Example
host1(config-subif)#atm atm1483 description nyc33
Use the no version to remove the text description or alias.
See atm atm1483 description.
Use to assign a text description or alias to the ATM interface.
The description can be a maximum of 255 characters and can include the # (pound
sign) character.
The first 32 characters of the ATM description are pushed out to RADIUS during
authentication and accounting.
Use the show atm interface command to display the description.
Example
host1(config-if)#atm description myAtm
Use the no version to remove the description or alias.
See atm description.
During authentication the router sends ATM interface descriptions to AAA. AAA passes
the descriptions to RADIUS, and they can appear in the Calling-Station-Id attribute [31].
(For information about RADIUS and the Calling-Station-ID attribute, see JunosE Broadband
Access Configuration Guide.)
By default, the router sends the major interface descriptions to AAA on the SRP. You can
configure the router to send VP interface descriptions in place of the major interface
descriptions, or to send ATM 1483 subinterface descriptions to AAA on the line module.
Chapter 1: Configuring ATM
41